CARLO GAVAZZI MDM 40 TF - CONFIGURATION SOFTWARE Manuel d'utilisateur télécharger pdf (Page 9)

UDM 35/40 PANEL METER USER MANUAL

Scaling the Inputs

When is displayed, access is available for configuring the

electrical input range, the decimal point position and display span as

follows:

Electrical Input Range (HiE and LoE)

Allows the operator to define an electrical input range different from the

standard range setup at the “inP” programming step. As example, a UDM

with a full-scale 20mA (19.99mA) setting, it is possible to select an

electrical input range from 4.00mA (Lo.E) to 19.99mA (Hi.E) by

proceeding as follows:

When is displayed, press . “LoE” will appear.

Using the key, toggle to select a digit, then press the or key to

choose the desired value. Using the key, repeat as necessary until all

digits have proper values. Press .

“HiE” will now appear.

Using the same procedure as above, toggle through the digits using the

key and choose the desired values with the or key. Press to

confirm and advance to the next parameter, Decimal Point Position.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 21 22

Pas de commentaire

CARLO GAVAZZI MDM 40 TF - CONFIGURATION SOFTWARE Manuel d'utilisateur Page 9